Ok, so i recently acquired a greddy emanage blue and wired it into the car. All went smoothly up until i tried to sync my laptop up to this bitch. I made a custom cable using a usb end and a rs232 to TTL converter plugged to a serial to usb. When i try to connect it will say online, but i cannot access any of the features only main unit update and if i try to do the update i either get a 'communication error. Check wiring' or nothing happens. If i switch com ports both in device manager and on the greddy software it does weird shit like i just mentioned or says offline and i have access to all the functions. Ive tried tool software 1.11 and 1.20 and this same shit happens.
Greddy Emanage Blue Software Serials
It will even say online if the fuckin plug isnt even in. I was dickin around with it more and now i can only choose between com 3 and com 4 in the greddy program. Those ports on my computer are already being used so now i dont even know what to do. Very fuckin frustrated, anybody know what im doing wrong here. Found this on another forum and it went unanswered this is exactly my problem so apparently it has happened before'Hi, from FinlandI have the same problem with my EMB, to what TD04 and danturbo had with them EMBI have tryed almost everything.I have the greddy serial cable. And the support tool software is downloaded from here:I have tryed 1,49 greddy support tool.When I try and do the following:Import DataUpdate the UnitReal Time DisplayNothing happens, it basically just show the progress bar and does nothing.But when I try with version 1,10 or 1,11. 2ff7e9595c
Comments